My search began looking through the quilting block books and resources that I have at home. Nothing really "spoke" to me, so I looked online. I am mindful that I have many small pieces of fabric - a repetitive type quilt is not an option. After a long search I've found one I really like. To be honest, it was a toss up between a triple irish chain, and Darlingoldlady's block. In the end I went for Darlingoldlady's - check out her photo here.
I've decided to call mine "Titirangi sunshine". I reminds me of a dappled sunshine streaming through the bush/forest. A kind of textured cheer. This quilt is going to pose a few challenges as I don't have a pattern, so I will have to draft from scratch.
The plan is to make this quilt will be big enough for a queen sized bed. So I'm aiming for a 90 inch square. Last night I did a rough draft layout using pencil and paper. The block size will be 10 inches. The bed top I will have at least 6 squares across, and I'll have a 15 inch drop on either side of the bed. As yet I haven't decided if the drops will be borders, or a continuation of the blocks. I'll let that idea perculate :) If you look at Darlingoldlady's picture, you would have already noticed that my finished blocks will be smaller than hers. I'm not sure what size hers are.
As I work through this quilt, I'll document my progress.
So this is what I did last night - drafting the block.
Next step... make a test block. Or should I say - what you should do... What did I do??? Purchased fabric! I needed white and beige for the squares. I don't have a large enough supply of this to do a whole quilt. Probably not a smart move, because I should have made a test square first just to see what the measurements would be, and how much fabric would be required. Also, to see if the block matched up to my expectations.
The next part, which was really quite time consuming was determining what sizes these patches should be cut (after adding the 1/4 inch seam allowance). I was then thinking about a cutting strategy. For example, if you have a large scrap, you could cut a square, then either cut it in half (diagonally) to make 2 triangles, or if the square was super large, you could cut it into quarters to make 4 triangles. All of these require different sizings. Then I also had to think about the "mini" scraps I had, and what was the smallest size that could be used. So I guess this all boils down to planning.
Yes, it would be easier with a pattern, but half the fun is using what you have on had, and your brain! :)
Okay, now that the thinking was done it is time to pull out the scraps. Here's the scraps I will be working with.
Then I choose fabric that is large enough to make at least 8 triangles to go around the centre.
Scraps are then ironed.
Now I'm ready for the cutting.

No comments:
Post a Comment